breeding setup
Posted: Mon Nov 12, 2012 5:03 am
Hello guys i have a 16 x 10 feet avairy which i want to make 4 sections for my 2 ringneck pairs which i have just gotten.
I will be getting 2 more pairs in the near future.
I want to make 8x4 foot sections for each pair. I have alot of mesh wire left so i want to separate each section with this wire. My only concern and question is that will it matter if each pair can see each other? Or will this put of the birds to breed?
I can separate each section with solid panels but this will cost alot more an will take alot mode time to make.
Any advice is appreciated. Thanks
I will be getting 2 more pairs in the near future.
I want to make 8x4 foot sections for each pair. I have alot of mesh wire left so i want to separate each section with this wire. My only concern and question is that will it matter if each pair can see each other? Or will this put of the birds to breed?
I can separate each section with solid panels but this will cost alot more an will take alot mode time to make.
Any advice is appreciated. Thanks